This project is read-only.

Newton Error?

Jul 22, 2010 at 7:03 PM
After following all of the instructions for installation and successfully building project 8 (Optical Marker Tracking) from the included tutorials, I encountered this error message: Unable to find an entry point named 'NewtonWorldFreezeBody' in DLL 'Newton.dll'. If anyone could shed some light on a solution to this error, it would be much obliged.
Jul 23, 2010 at 1:29 AM

It's most likely you're using Newton 2.0, but you should use Newton 1.53. The API is quite different.

Next release will contain a wrapper for Newton 2.0 as well, but current release only contains wrapper for 1.53.